We’ve got an HP Proliant ML310 (G4) server. sure, an antique one. i am unable to open it for some thing on the motherboard or memory slots have malfunctioned. So, I contact you to enquire if you will be able to open the apparent RAID pressure and extract that statistics. I don’t know which RAID stage. There are four HDDs with each 1TB. seeing that I started work here it has only started up once and that went right into a linux textual content based login web page however truly I don’t even realize if I came to the RAID power or to the opposite 5th drive this is without delay linked (no longer thru the RAID controller card) to the mother board. How I recognize it is RAID is because I attempted to take one out to any other computer and it could not open it so I put it lower back as I then understood that it have to be a few kind of RAID degree on these drives. I don’t know in case you need the entire server to test or what you want? What could you guess a rate for this sort of operation could be?
The advice I give is to Google for some technical blogs that will assist with your predicament. I did a quick search myself and came up with http://guyfff.fotopages.com/> andhttps://www.extremetech.com/.
Western virtual My Passport 1TB outside power powers up and mild comes on. It feels like the whole thing is spinning good enough and i’m able to see the disk pressure within the device supervisor but it may not show up in home windows Explorer. If I run the WD diagnostics it sees the disk but fails. In Disk management it suggests the disk however can not initialise it because of an I/O device blunders. I would love to get better the information off the disk if viable. i am no longer troubled approximately getting the disk running again if i can just get the facts again.